Husqvarna 445 - Freeing Trapped Trees and Cutting Tensioned Limbs; Kickback Identification and Prevention; Definition of Kickback

English – 29
Repair instructions
7.8 gnitin ule an heel
 retting
1
Fit the ywheel on the crankshaft ournal. Turn the
ywheel so that the key lines up with the keyway in
the shaft.
Fit the nut on the shaft and tighten to a torque of
25-30 m. (see gure 11)
2
To ret the ignition module proceed as follows
Turn the ywheel so that the magnets are in line with
the ignition module. Fit the ignition module with the
plastic feeler gauge (502 51 34- 02) held in position
at the same time, without tightening the bolts. Fit the
earth cable (black) (A). Set a distance of 0.3 - 0.1
mm, between the ignition module and magnet. The
measurement applies to the two lowest lugs on
the ignition module. Tighten the screws, tightening
torque 4.5–6 Nm. Fit the blue cable on the ignition
module. (see gure 12)
3
Then ret
• cable guide and press the leads into position
• HT lead
• starter assembly, tighten to a torque of 2.5–3.5
Nm
• cylinder cover
hen replacing the cables they are tted on the
stop switch as shown in middle gure on the pre-
vious page.
A
Air gap tool
Fig 12
Fig 11