Husqvarna 445 - Replacing the Bar Bolt

52 – English
Repair instructions
7.29 Replacing the bar bolt
Replacing the front bar guide.
1
Drain the oil tank.
2
nock through the old guide bar bolt so that it falls
into the oil tank.
3
Remove the bolt from the oil tank.
4
Secure steel wire to the outer part of the bar bolt
(A), thread the steel wire through the oil tank and
out through the bolt hole in the crankcase. (see
gure 69)
5
Pull the steel wire so the bolt comes out of its hole.
(see gure 69)
6
Check that the bolts suare head ts in
the washer (D) which is positioned in the cut-out in
the crankcase.
7
Pull out the bar bolt with its nut. Place a spacer
between the nut and crankcase. (see gure 69)
8
Rell with chain oil.
Replacing the rear bar guide
1
Pull out the bar guide (C) with the help of slip-joint
pliers. (see gure 68)
2
Fit the bar guide with the help of a hammer.
Fig 68
Fig 69