Husqvarna 445 - Felling Hinge Control for Direction

28 – English
Repair instructions
7.7 gnitin uleheel  real
1
Remove the cylinder cover. Disconnect the HT lead,
remove the spark plug and t piston stop 502 54 15-
01. in its place. Take off the starter assembly release
the leads from the cable guide and remove it. (see
gure 8)
4
Knock on the punch using a metal mallet until
the ywheel releases from the shaft. Remove the
punch and the ywheel. (see gure 10)
leaning an inpectin
• Clean all parts, especially the tapers on the
ywheel and shaft.
 Check that the ywheel is not cracked or da-
maged in any other way.
2
f replacing the ignition module (B) loosen the
cable lug (C) and screw (A) and unscrew it. The
ignition module can be left in place if you are simply
removing the ywheel. (see gure 9)
3
Loosen the ywheel nut () using a suitable socket
and remove it.(see gure 10)
hen replacing the cables they are tted on the
stop switch. as shown in gure. (see gure 9)
E
A
C
D
A
B
Fig 9
Fig 8
Fig 10