Husqvarna 445 - Spark Plug and Bar Lubrication; Cooling System Cleaning

36 – English
Repair instructions
A
B
G
D
H
E
F
M
L
J

C
N
P
8. Dismantle the cover (A) on the metering unit
and carefully remove the control diaphragm (B)
with gasket.
9. Dismantle the screw (F) and lift out the jet
valve (E) with lever (D), shaft (G) and spring
(H).
10. Dismantle the cover () on the pump unit
and carefully remove the gasket (L) and di-
aphragms (M).
11. Use a needle or the like and carefully remove
the fuel screen (J).
12. Dismantle the high (N) and low jet screws.(P)
13. If necessary remove the throttle and choke val-
ves, also dismantle the shafts with lever arms
and springs.
(see gure 31)
Fig 31