Husqvarna 536LiPX - Index

4 – English
Index
Index
B
Basic dismantle/assembly 20
Bar and chain 22
Battery 21
Battery housing 22
Control handle 22
Trigger guard 21
Wear guard under battery housing 21
D
Diagnosis and troubleshooting 16
Connect the diagnostic tool 17
No signal to diagnostic tool 17
Overhaul 19
Remove the battery 17
Troubleshooting the BLDC control unit 19
Troubleshooting the main switch 18
I
Introduction and safety regulations 7
General 7
General directions 8
Numbering 7
Revisions 7
Security 7
Special directions 8
Structure 7
Symbols in the Workshop Manual 9
Symbols on the pole saw 9
Target group 7
Tools 7
R
Repair instructions 26
Assemble the oil pump and/or chain tensioner,
branch hook 32
Assembling the control cabling 43
Assembling the control unit 45
Assembling the main switch 41
Assembling the motor 29
Assembling the shaft and motor cabling 37
Assembling the shaft and motor cabling (536LiP4,
536LiPX) 34
Changing the EMC filter 39
Changing the handle 45
Dismantling shaft and motor cabling (536LiP4,
536LiPX) 33, 35
Dismantling the control cabling 42
Dismantling the control unit 44
Dismantling the main switch 40
Dismantling the motor 27
Dismantling the oil pump and/or chain tensioner,
branch hook 32
Dismantling the oil tank 31
General repair instructions 27
S
Safety equipment 24
Assembling the throttle trigger lock and throttle
trigger 25
Dismantling the throttle trigger lock and throttle
trigger 25
Service data 12
Service tools 11
T
Technical Data 10
Troubleshooting 18
Troubleshooting the BLDC control unit 19
Troubleshooting the main switch 18