ASSEMBLY
English – 19
Assembling the branch hook
Assemble the twig guard with the two screws.
Dismantling the shock guard
(Dismantle if necessary)
• Dismantle the shock guard by unscrewing the screws.
• Assemble the shock guard using the screws.
Harness (Accessory)
Single harness
• Adjust the length of the harness so that the support
hook is roughly level with your right hip.
Assembling the harness to the backpack
battery
• Remove the breast strap attachments to the harness
with a pair of nippers or the like.
• Insert the new breast strap into the harness carry
strap. Start with the lower part first and then the upper
part of the attachment.
NOTE!
Make sure the breast strap attachment is above the seam
on the carry strap.
• Continue with the attachment eye on the carry strap.
Adjusting the harness
You should always use the harness with the machine to
give maximum control over the machine and reduce the
risk of fatigue in your arms and back. The product,
including battery and cutting equipment, with harness is
correctly balanced when your arm is lightly bent and the
Li-ion
To Next Page
Loading...
