Husqvarna 560XP - Table of Contents; Contents

CONTENTS
4 – English
Contents
KEY TO SYMBOLS
Symbols on the machine: ...................................... 2
Symbols in the operator’s manual: ........................ 3
CONTENTS
Contents ............................................................... 4
INTRODUCTION
Dear Customer, ..................................................... 5
WHAT IS WHAT?
What is what on the chain saw? ........................... 6
GENERAL SAFETY PRECAUTIONS
Before using a new chain saw .............................. 7
Important .............................................................. 7
Always use common sense .................................. 8
Personal protective equipment ............................. 8
Machine ′ s safety equipment ................................. 8
Cutting equipment ................................................. 11
ASSEMBLY
Fitting the bar and chain ....................................... 17
FUEL HANDLING
Fuel ....................................................................... 18
Fuelling ................................................................. 19
Fuel safety ............................................................ 19
STARTING AND STOPPING
Starting and stopping ............................................ 20
WORKING TECHNIQUES
Before use: ............................................................ 22
General working instructions ................................ 22
How to avoid kickback ........................................... 28
MAINTENANCE
General ................................................................. 29
Carburettor adjustment ......................................... 29
Checking, maintaining and servicing chain saw
safety equipment .................................................. 29
Muffler ................................................................... 31
Starter ................................................................... 32
Air filter .................................................................. 33
Spark plug ............................................................. 33
Lubricating the bar tip sprocket ............................. 33
Needle bearing lubrication .................................... 33
Adjustment of the oil pump ................................... 34
Cooling system ..................................................... 34
”Air Injection” centrifugal cleaning ......................... 34
Winter use ............................................................. 34
Heated handles ..................................................... 35
Maintenance schedule .......................................... 36
TECHNICAL DATA
Technical data ....................................................... 37
Bar and chain combinations .................................. 39
Saw chain filing and file gauges ............................ 39
EC-declaration of conformity ................................. 40