Husqvarna 701 Enduro 2018 User Manual

TUNING THE ENGINE 17
221
17.2 Adjusting the basic position of the shift lever
401950-12
–
Remove screw
1
with the washers and take off shift
lever
2
.
401951-10
–
Clean gear teeth
A
of the shift lever and shift shaft.
–
Mount shift lever
2
on the shift shaft in the required position
and engage the gearing.
Info
The range of adjustment is limited.
The shift lever must not come into contact with any
other vehicle components during the shift procedure.
–
Mount and tighten screw
1
with washers.
Guideline
Screw, shift
lever
M6 14 Nm (10.3 lbf ft)
Loctite
®
243™

Husqvarna 701 Enduro 2018 Specifications

General

Engine Type	Single-cylinder, 4-stroke
Displacement	692.7 cc
Bore x Stroke	105 mm x 80 mm
Compression Ratio	12.6:1
Starter	Electric
Transmission	6-speed
Final Drive	Chain
Front Tire	90/90-21
Rear Tire	140/80-18
Power	74 hp (55 kW) @ 7, 500 rpm
Fuel System	Fuel injection
Front Suspension	WP USD, 48 mm
Rear Suspension	WP monoshock
Front Brake	300 mm disc
Rear Brake	Brembo 240 mm disc
ABS	Yes, switchable
Ground Clearance	270 mm
Fuel Capacity	13 liters (approx. 3.4 gallons)
Dry Weight	145 kg