If the product is disrupted in any way, for
example it is trapped or the battery is low, a
message is saved relating to the disruption and
the time it happened.
If the same message is repeated several times,
this may indicate that an adjustment to the
installation or the product is required. Refer to
Installation on page 16
.
To read the messages
1. Do steps 1–3 in
To get access to the menu
on page 26
.
2. Use the arrow buttons and the OK button to
move through the menu structure
Messages
> Fault messages
and
Messages > Info
messages
.
3. Read the messages and read the
Troubleshooting
to get information and
recommendations to correct the faults.
3.12.3 Weather timer
Weather timer
automatically adjust the cutting
time to the growth of the grass. The product is
not permitted to operate more than the schedule
settings.
Note:
When using
Weather timer
, it is
recommended to make as much operating time
as possible available for
Weather timer
. Do not
restrict the schedule more than necessary.
The first operation of the day is set by the
schedule settings. The product always complete
1 mowing cycle, and then
Weather timer
selects
if the product will continue to operate or not.
Note:
Weather timer
is reset if the product does
not operate for more than 50 hours, or if a
Reset
of all user settings
is done.
Weather timer
is not
changed if a
Reset of schedule settings
is done.
3.12.3.1 To set the Weather timer
1. Do steps 1–3 in
To get access to the menu
on page 26
.
2. Use the arrow buttons and the OK button to
move through the menu structure
Weather
timer > Use Weather timer
.
3. Push the
OK button to select the
Weather
timer
.
4. Push the BACK button.
3.12.3.2 To set the Weather timer frequency
Set how frequently the product cuts the grass
when the
Weather timer
is in use. There are 3
frequency levels:
Low, Mid
and
High
. The higher
the frequency, the more sensitive the product is
to the grass growth. That is, if the grass growth is
high then the product is allowed to work longer.
Note: If the mowing results are not optimal when
using
Weather timer
, the schedule settings may
need adjusting. Do not restrict the schedule more
than necessary. Also, check that the blade disc is
clean and that the blades are in good condition.
1. Do steps 1–3 in
To get access to the menu
on page 26
.
2. Use the arrow buttons and the OK button to
move through the menu structure
Weather
timer > Cutting time
.
3. Use the arrow buttons to select
Low, Mid
or
High
frequency.
4. Push the BACK button.
3.12.4 Lawn Coverage
If the work area includes remote parts that are
connected with narrow passages, the
Lawn
Coverage
function is useful to be able to maintain
a well-cut lawn in all parts of the yard. A guide
wire must be installed to use the functions. You
can set a maximum of 3 remote areas.
With the
Lawn Coverage
function the product first
follows and then leaves the guide wire after a
certain distance and starts to mow the lawn.
Area A, approximately 50%
Area B, approximately 30%
Area C, approximately 20%
1201 - 004 - 25.03.2020
Installation - 29
To Next Page
Loading...
