To set the Flashes when fault function
The headlights flashes if the product stops to
operate because of a fault if
Flashes when fault
is
enabled.
1. Do steps 1–3 in
To get access to the menu
on page 26
.
2. Use the arrow buttons and the OK button to
move through the menu structure
Accessories > Headlights > Flashes when
fault
.
3. Use the OK button to enable or disable the
Flashes when fault
function.
3.12.13.8 To avoid collisions with the mower
house
The wear on the product and the mower house
decreases when you select
Avoid collisions with
mower
.
1. Do steps 1–3 in
To get access to the menu
on page 26
.
2. Use the arrow buttons and the OK button to
move through the menu structure
Accessories > Mower house > Avoid
collisions with mower
.
Note: If
Avoid collisions with mower
is selected it
can result in grass that is not cut around the
charging station.
38 - Installation
1201 - 004 - 25.03.2020
To Next Page
Loading...
