Husqvarna AUTOMOWER 435X AWD - 4.6 Adjusting Cutting Height

4.6 To adjust the cutting height with
Automower
®
Access
The cutting height can be varied from MIN (3 cm /
1.2 in.) to MAX (7 cm / 2.8 in.).
Note: During the first weeks after a new
installation, the cutting height must be set to MAX
to avoid damaging the loop wire. After this, the
cutting height can be lowered step by step every
week until the desired cutting height has been
reached.
1. Push the STOP button to stop the product.
2. Use the jog wheel to select Settings .
3. Use the jog wheel to select the cutting
height symbol.
4. Turn the jog wheel to change the cutting
height.
5. Push the jog wheel to select the cutting
height.
1-9
1404 - 002 -
Operation - 39