Messages
Number Message Cause Action
INSTALLATION
15 Mower lifted The lift sensor has been activated due
to the product getting stuck.
Free the product and rectify the reason.
One of the lift senor magnets is inver-
ted or missing.
Check the magnet. Refer to
To replace
the lift sensor circuit board on page 31
.
The lift sensor is faulty. Check the lift sensor. Refer to
To re-
place the lift sensor circuit board on
page 31
.
13/78 No drive The product has got caught in some-
thing.
Free the product and rectify the reason
for the lack of drive. If it is due to wet
grass, wait until the lawn has dried be-
fore using the product.
The work area includes a steep slope. Check the maximum guaranteed slope.
Steeper slopes should be isolated.
The guide wire is not laid at an angle
on a slope.
Lay the guide wire at an angle across
the slope.
10 Upside down The product is leaning too much, or
has turned over.
Turn the product the right way up and
rectify the reason.
50/51/52 Guide not found The product is no longer receiving sig-
nals from the guide wire.
Check connection of guide wire to
charging station. To locate a break in a
wire, refer to
To find a break in the
boundary loop on page 58
.
55 Difficult finding home The product has followed the boundary
wire but has not found the charging
station.
Check the boundary wire's corridor
width setting and location. Refer to the
Operator's manual.
56 Guide calibration ac-
complished
Guide wire calibration has been suc-
cessful.
No action.
57 Guide calibration failed Guide wire calibration has failed. Check that the guide wires are installed
according to instructions. Then carry
out a new calibration. Refer to
Tools -
Calibrate on page 14
.
48 - Troubleshooting 1191 - 001 -
To Next Page
Loading...
