Messages
Number Message Cause Action
CHARGING STATION
17 Charging station
blocked
An object is obstructing the product. Remove the object.
The baseplate is bent. Ensure that the baseplate is placed on
level ground.
The contact between the charging
strips and contact strips may be poor
and the product has made a number of
attempts to charge.
Put the product in the charging station
and check that the charging strips and
contact strips make good contact.
16 Stuck in charging sta-
tion
There is an object in the way of the
product preventing it from leaving the
charging station.
Remove the object.
The product slides on the baseplate. Clean the baseplate.
37 Charging current too
high
The battery is being charged with too
high current.
Fault in the power supply, or wrong
type of power supply or charging sta-
tion is being used.
26 Invalid sub-device
combination
Unknown combination of firmware ver-
sions in the HMI circuit board and the
main circuit board.
Program the product with the most re-
cent main program. Refer to
Firmware
on page 16
.
52 - Troubleshooting 1191 - 001 -
To Next Page
Loading...
