Messages
Number Message Cause Action
INTERNAL DIAGNOSTICS
505 Electronics problem The parameter for the type of product
is different in the HMI circuit board and
main circuit board.
The parameter can only be entered at
the initial programming of the main cir-
cuit board. It may not be changed after-
wards. Replace the main circuit board
and ensure that the correct product
model is selected.
A used HMI circuit board can only be
used if it has previously been installed
to the same type of product. You can
not use an HMI circuit board from an
other model.
702 Connection settings re-
stored
Settings for wireless connectivity have
been restored due to an error.
Check and revise settings if necessary.
706 Weak signal Weak GPRS signal for Automower
®
connect module.
Make sure that the product is not up
side down. If the problem persists, refer
to
To replace the communication circuit
board, 420/440 only as accessory on
page 29
.
707 SIM card requireds
PIN
The SIM card must be unlocked. Make sure that the correct SIM PIN has
been entered into the products menu
(Network > SIM card). Refer to
Tools -
Info - Automower
®
Connect on page
11
.
708 SIM card locked The SIM card must be replaced. Refer to
To replace the SIM card,
420/440 only as accessory on page 30
.
709 SIM card not found Automower
®
connect requires a SIM
card to be inserted in the product.
Refer to
To replace the SIM card,
420/440 only as accessory on page 30
.
713 Geofence problem Your Geofence is not working due to
poor (or no) communication with the
GPS system.
Refer to
Tools - Test - GPS navigation
(not for 420/440) on page 13
.
714 Weak GPS signal Not applicable for Automower
®
420.
The GPS signal is weak for the current
work area. GPS assisted navigation
cannot be used.
If the message appears often, turn off
the GPS assisted navigation and in-
stead use the manual settings for lawn
coverage. Refer to
Tools - Test - GPS
navigation (not for 420/440) on page
13
.
Temporary problem
with the server
Try again. In case of persisting problem, refer to
To replace the communication circuit
board, 420/440 only as accessory on
page 29
.
717 SMS could not be sent Poor GSM coverage.
Maximum number of SMS reached.
Maximum 10 SMS per month can be
sent to the product.
No funds left on the SIM card.
724 ComBoard SW must
be updated
New communication circuit board or
faulty communication circuit board.
Update firmware via Autocheck.
1191 - 001 - Troubleshooting - 51
To Next Page
Loading...
