To set the reversing distance
1. Select
Settings > Installation > Reversing distance
in the app.
2. Move the horizontal bar to set the distance.
3. Select
Save
.
3.11.3.6 Drive Past Wire
The front of the product always moves past the
boundary wire by a specified distance before the product
moves back into the work area. The factory setting for
the
Drive Past Wire function
function is 37 cm / 15 in.
You can select a distance of 20-50 cm / 8-19 in.
Note: With the factory setting the product will cut 11
cm / 4 in. past the wire.
Note: If the
Drive Past Wire
distance is changed, the
distance will change along the boundary wire
everywhere in the work area.
To set the Drive past wire
1. Select
Settings > Installation > Drive past wire
in
the app.
2. Move the horizontal bar to set the distance.
3. Select
Save
.
3.11.4 Accessories
Settings for accessories mounted on the product can be
made in this menu.
3.11.4.1 To avoid collisions with the mower house
When this option is enabled, the wear on the product
and the house is reduced, but it can result in more uncut
grass around the charging station.
1. Select
Settings > Installation > Mower house
in the
app.
2. Select
on/off
to enable or disable the function.
3. Select
Save
.
3.11.4.2 To set the ultrasonic
1. Select
Settings > Installation >Ultrasonic
in the
app.
2. Select
on/off
to enable or disable the function.
3. Select
Save
.
3.11.5 General (Bluetooth
®
only)
This function is used to set time and date, or to reset to
default settings.
3.11.5.1 Time & date
The time and date can be changed manually, or by
using the time and date from the mobile device.
To set the time & date
1. Select
Settings > General > Time & Date
in the
app.
2. Select
Time & Date from phone
or select the pencil
to enter the correct time and date.
3. Select
Save
.
3.11.5.2 Reset to factory settings
The user settings can be reset to factory settings.
Note:
PIN code, Loop signal, Messages
and
Date &
Time
will not be reset.
To reset to factory settings
1. Select
Settings > General > Reset
in the app.
2. Select
Reset to factory settings
.
3.11.6 Security (Bluetooth
®
only)
The security settings controls the PIN code, the
GeoFence and other security functions. The correct PIN-
code must be entered to get access to the
Security
menu in the Automower
®
Connect app.
3.11.6.1 New loop signal
The loop signal is randomly selected to create a unique
link between the product and the charging station. In
rare cases, there may be a need to generate a new
signal, for instance if 2 adjacent installations have a very
similar signal.
To create a New loop signal
1. Put the product in the charging station.
2. Select
Security > New loop signal > Create new
loop signal
in the app.
3. Select
Save
.
4. Wait for confirmation that the loop signal has been
generated. This usually takes about 10 seconds.
28
- Installation 1457 - 005 - 16.10.2020
To Next Page
Loading...
