20
Tracking Knob
If the mower is not tracking straight, check the
air pressure in both rear tires. Recommended air
pressure for the rear tires is 15 psi (1 bar).
Tracking adjustments are made using the tracking 1.
bolt and tracking knob. The tracking bolt and
tracking knob act as limiting devices for the
motion control levers when in the full-forward
position.
For preliminary tracking adjustment, move unit 2.
to an open, unobstructed area such as an empty
parking lot or open eld.
Back the tracking bolt out until ush with nut.3.
Loosen tracking knob out until ush with nut.4.
Test operate unit by driving it at full throttle and 5.
the full forward position on both motion control
levers. Gradually turn in the tracking bolt on the
right hand side until the unit noticeably starts
drifting right.
Drive forward at full throttle with both motion 6.
control levers in the full forward position.
Gradually turn in the tracking knob (left side) until
unit tracks straight.
Hour Meter
The hour meter displays the total operating time.
It will ash CHG OIL (Change Oil) at 50 hour intervals.
The ash duration is one hour before and one hour
after the interval. The CHG OIL icon will come on
and shut off automatically. The hour meter cannot be
manually reset.
8065-084
Hour meter
8065-086
Tracking adjustment
To Next Page
Loading...
