31
Running
Release the parking brake by moving the lever 1.
downward.
NOTE: The mower is equipped with an operator
presence system. When the engine is running,
any attempt by the operator to leave the seat
without rst setting the parking brake will shut off
the engine.
Move the steering controls to the neutral position 2.
(N).
The cutting height can be set from 1"- 5½" 3.
(2.5 cm-14 cm) by setting the cutting height pin
into the desired hole. Release deck height control
by pushing forward on the pedal.
Set pin at desired cutting height. (Pin is removed 4.
by rotating 180
O
.) Push pedal again to lower deck
to selected setting.
8065-006
Release the parking brake
8065-087
Deck lift pedals
8065-090
Set deck to selected cutting height
To Next Page
Loading...
