Husqvarna P524 EFI - Page 35

13. Disconnect the PTO clutch.
14. Remove the torque stop for the PTO clutch.
15. Remove the PTO belt from the PTO clutch.
16. Remove the hydraulic pump belt. Refer to To
replace the hydraulic pump belt on page 55 .
17. Remove the cover for the pump drive belt to get
access to the front engine fixtures.
18. Remove the 4 engine fixtures.
19. Use the lift plates to lift the engine. Make sure not to
do damage to the PTO clutch when you lift the
engine.
20. Install the engine in the opposite sequence.
9.2.2 To remove the PTO clutch
1. Remove the engine. Refer to
To remove and install
the engine on page 33 .
2. Hold the pulley (B) below the PTO clutch (A) with a
wrench.
3. Remove the screw (C).
C
A
B
662 - 001 - 23.10.2018 Repair instructions - 35