b) To replace the fuse for the power outlet, remove
the side cover of the control panel. The fuses for
the power outlet is below the control panel.
2. Pull the fuse from the holder.
3. Replace the blown fuse with a new fuse of the same
type. Refer to
Technical data on page 84
.
4. Attach the covers.
9.3.6 To replace a broken lamp
1. Remove the 2 screws, one on each side, and
remove the cover.
2. Disconnect the cables at the connection (A).
3. Disconnect the cables from the broken lamp.
4. Push the broken lamp toward the inner lamp
attachment (B).
5. Lift the outer edge (C) of the lamp to remove the
lamp.
6. Replace the broken lamp. Use the type of lamp as
given in
Technical data on page 84
.
7. Connect the cables to the new lamp.
8. Connect the cables at the connection (A).
9. Attach the cover and tighten the 2 screws.
40 - Repair instructions 662 - 001 - 23.10.2018
To Next Page
Loading...
