Husqvarna P524 EFI - Page 58

8. Loosen the rear end of the control stay (A) from the
linkage (B). Remove the nut (E), screw (C) and
bushing (D).
D
C
E
B
A
G
H
F
9. Loosen the front end of the control stay (A). Remove
the nut (G), screw (F) and washer (H).
10. Remove the 2 screws that hold the bearing unit on
each side of the transmission.
11. Remove the stop screws.
12. Remove the bearing unit.
13. Remove the joint screw.
14. Remove the 3 screws that hold the transmission.
58 - Repair instructions 662 - 001 - 23.10.2018