3. Adjust the cable until the distance between the
ground and the front of the cutting deck cover is 25
mm.
Note: If the cutting height in one of the cutting height
positions is adjusted, the other cutting heights are
equally changed.
4. Adjust the cable at the tool frame if the first
adjustment is not sufficient to get the correct cutting
deck height.
9.7.8 To replace the cutting height adjustment
cable
1. Remove the cutting deck. Refer to
To remove the
cutting deck on page 63
.
2. Release the lift chain from the tool frame.
3. Remove the protection cover on the tool frame.
4. Remove the pulley and the cable retainer.
5. Loosen the locknuts on the cable sheath.
6. Pull back the rubber protection until the cable can go
through the bracket opening.
7. Push the cable out of the rubber strap.
8. Remove the control side cover.
9. Loosen the front lock on the cable.
66 - Repair instructions 662 - 001 - 23.10.2018
To Next Page
Loading...
