Husqvarna R 214T - To replace the engine oil and oil filter

Note: The belt pulley groove must align with the
output shaft key. Make sure that the spacer pipe (A)
and shaft key (B) are attached to the engine shaft.
Put grease on the engine shaft when you attach the
engine belt pulley.
A
B
9.2.2 To remove and install the muffler
1. Remove the engine cover. Refer to To open the
engine cover on page 18 .
2. Remove the heat shield.
3. Remove the clamp on the exhaust pipe.
4. Remove the 2 screws and the muffler.
5. Install in the opposite sequence.
9.2.3 To replace the engine oil and oil filter
If the engine is cold, start the engine for 1–2 minutes
before you drain the engine oil. This makes the engine
oil warm and easier to drain.
WARNING: Do not operate the engine for more
than 1–2 minutes before you drain the engine
oil. The engine oil becomes very hot and can
cause burn injuries. Let the engine become cool
before you drain the engine oil.
WARNING: If you spill engine oil on your body,
clean with soap and water.
1. Put a container below the oil drain plug.
2. Open the plastic cap on the end of the oil drain plug.
3. Attach a plastic hose to the end of the oil drain plug
to prevent spill.
26 - Repair instructions 1676 - 001 - 26.11.2021