Husqvarna T435 - Refueling Safety Procedures; Transport and Storage Guidelines

English – 19
Safety equipment
Fig 11
4
Insert the screwdriver into the end of the spring
and press the spring together while pushing it
down with the fi nger.
5
Hold the spring in place with your fi nger and
remove the screwdriver. Insert the screwdriver
straight from above and press down until the spring
catches against the cut-out edge.
Fig 12
6
Bend the screwdriver away from the spring so that
the spring is pressed together and slips down to
the bottom.
Fig 13
7
Fit and tighten the cover. Clamp the brake by mo-
ving the handle backwards, see fi gure 14.
Fig 14
8
Fit the kickback guard, see fi gure 15.
Fig 15