Husqvarna T435 - Assembling the Complete Crankshaft; Dismantling the Crankcase and Crankshaft; Replacing the Crankshaft Bearing

52 – English
Repair instructions
7.25 Dismantling the crankcase and
crankshaft
1
See chapter “Dismantling the piston and cylinder”.
7.26 Replacing the crankshaft bearing
Remove:
• the crankshaft completely from the crankcase.
1
Pull out the crankshaft bearing from the crankshaft,
see fi gure 88.
Fig 89
2
Fit the new bearing on the crankshaft using tool
502 50 30-18, see fi gure 89.
7.27 Assembling the complete crankshaft
1
See chapter “Assembling the piston and cylinder”.
Fig 88