20 – English
Safety equipment
WARNING!
Do not touch the muffl er before it
has cooled down. Risk of burns.
6.3. Dismantling the muffl er
1
Release the brake by moving the kickback guard
backwards.
Loosen the bar nut and remove the clutch cover,
chain and bar.
Fig 16
Fig 17
6.5 Replacing the chain catcher
A worn chain catcher must always be replaced with
a new one.
1
Loosen the screw and replace the chain catcher
with a new one as shown in fi gure 21.
Fig 18
Fig 19
Fig 20
6.4 Assembling the muffl er
1
Assemble the muffl er as shown in fi gure 20, tighte-
ning torque 12-14 Nm. The square screws should
be slided in the slot on the cylinder. Assemble the
chain, bar and clutch cover.
3
Warm up the saw for at least 1 minute and retigh-
ten the muffl er screws with 12-14 Nm.
2
Loosen screws 1 and 2, see fi gure 17.
3
Slide the muffl er cover as shown in fi gure 18.
4
Loosen the screws and nuts. Remove and check that
the muffl er is complete, see fi gures 19 and 20.
Cleaning and checking
Clean and check all components carefully.
Parts must be replaced if cracked or showing signs
of other defects.
Never use the saw with a muffl er that is in bad con-
dition. Always use original spare parts.
Fig 21
To Next Page
Loading...
