Husqvarna T435 - Dismantling the Piston and Cylinder; Vibration Damping System

48 – English
Repair instructions
7.22 Vibration damping system
Dismantling
1. Dismantle the following parts:
• Chain and bar, see the operator’ s manual.
•
Handle unit.
2. Dismantle the springs as shown in fi gures 70, 71
and 72.
Cleaning and checking
Clean and inspect all parts.
Assembly
1. Assemble the springs as shown in fi gures 70,
71 and 72.
Note! Springs with greater resistance are available,
but must only be used together with longer bars.
See the spare parts list for spare part number.
2. Assemble the following parts:
• Handle unit.
• Chain and bar, see the operator’ s manual.
Fig 71
Fig 70
Fig 72
7.23 Dismantling the piston and
cylinder
1
Dismantle:
• tank unit, see chapter ”Dismantling the intake
system”.
• ignition module and fl ywheel
• pump unit
Dismantle the inlet bellows, see chapter ”Dismantling
the inlet bellows”.
Fig 73
2
Dismantle the muffl er, see chapter ”Dismantling the
muffl er”.