Name: Husqvarna TE 250 - 310 2011 I.E.
Brand: Husqvarna
Rating: 4 (1 reviews)

To Next Page

To Previous Page

EN - 45

REMOVING THE REAR WHEEL

Unscrew the nut (1) of the wheel pin (3) and extract it. It is

not necessary to unloose the chain adjusters (2); in this way,

the chain tension will remain unchanged after the reassembly.

Extract the complete rear wheel, by taking care of the spacers

located at the hub sides.

To reassemble, reverse the above procedure remembering to

insert the disc into the caliper.

NOTES

Do not operate the rear brake pedal when the wheel has been

removed; this causes the caliper piston to move outwards.

After removal, lay down the wheel with brake disc on top.

After reassembly, pump the brake control pedal until the pads

are against the brake disc.

Other manuals for Husqvarna TE 250 - 310 2011 I.E.

Questions and Answers:

Need help?

Do you have a question about the Husqvarna TE 250 - 310 2011 I.E. and is the answer not in the manual?

General