Husqvarna TE 250 - 310 2011 I.E. User Manual

b)
C
D
TE
2
A
4
1
3
1
3
2
A
EN
EN - 37
NOTE
Flexibility index for the serial springs:
K=8,8 N/mm (TC-TXCi)
K=89,2 N/mm (TE)
NOTE
Always replace both the spring and the spacers to keep the pre-
load value unchanged.
b) Handlebar height change
Remove the lower spacer (A) then replace the screw (4) with a
new one of L=65 mm (2.56 in.) height.
Once these operations are completed, tighten the screws (3) to
2,75-3,05 kgm (27-30 Nm; 19.9-22 Lb/fts) and the screws (4)
to 2,0-2,2 kgm (19,6-21,6 Nm; 14.5-15.9 Lb/fts).
HANDLEBAR POSITION AND HEIGHT CHANGE
The handlebar position (a) and height (b) can be changed for
better suiting Your driving requirements. To effect these opera-
tions, remove the upper clamp (1) and the lower one (2), after
removing the fixing srews (3) and (4).
a) Handlebar position change
Turn the lower clamp (2) 180° to move forward or backward
(10mm- 0.04in.) the handlebar position with respect to the
original setup.

Husqvarna TE 250 - 310 2011 I.E. Specifications

General

Year	2011
Manufacturer	Husqvarna
Model	TE 250 - 310 I.E.
Category	Motorcycle
Displacement	249.5 cc
Fuel System	Electronic Fuel Injection
Transmission	6-speed
Fuel Tank Capacity	8.5 L
Starter	Electric
Cooling system	Liquid cooling
Rear suspension	Monoshock
Front brake	Disc brake
Rear brake	Disc brake
Front suspension	USD fork, 48 mm