Name: Husqvarna TE 250 - 310 2011 I.E.
Brand: Husqvarna
Rating: 4 (1 reviews)

To Next Page

To Previous Page

TE - TXCi

EN - 17

GEAR SHIFT CONTROL

The lever (1) is placed on the left-hand side of the engine. The

operator must release the lever after each gear change to allow

it to return to its central position before another gear

change can be made.

Neutral position (N) is between first (low) and second gears.

First gear is engaged by pushing the lever downwards; all the

other gears are engaged, by pushing the lever upwards.

The position of the gear shift lever on the shaft can be varied

by:

- loosening screw;

- pulling lever out;

- placing lever in new position on the shaft when the operation

is over tighten the screw and then tightening the screw.

CAUTION*: Do not shift gears without disen-

gaging the clutch and closing the throttle. The

engine could be damaged by overspeed and

shock.

WARNING*: Do not downshift when traveling

at a speed that would force the engine to

overrev in the next lower gear, or cause the

rear wheel to lose traction.

REAR BRAKE CONTROL

The rear brake control (1) is placed on the right-hand side of

the motorcycle.

N: Neutral

Other manuals for Husqvarna TE 250 - 310 2011 I.E.

Questions and Answers:

Need help?

Do you have a question about the Husqvarna TE 250 - 310 2011 I.E. and is the answer not in the manual?

General