Name: Husqvarna TE 250 - 310 2011 I.E.
Brand: Husqvarna
Rating: 4 (1 reviews)

To Next Page

To Previous Page

EN - 38

4. The difference between these two measurements constitutes

the “SAG” of the motorcycle’s rear end.

Suggested SAG: 4 in. with cold shock absorber. 3.7 in. with

warmed up shock absorber.

5. To get the right SAG according to your weight, adjust the

shock absorber spring preload as described at side.

WARNING*: Never disassemble shock ab-

sorber, which contains highly compressed

nitrogen. Contact your Dealer for such major

service. Do not incinerate.

ADJUSTING THE SHOCK ABSORBER SPRING PRELOAD

Proceed as follows:

1. First turn counterclockwise fastening rear pin (1) then remo-

ve saddle, screws (2) and R.H. side panel (3).

ADJUSTING THE SHOCK ABSORBER

The rear shock absorber must be adjusted according to the rider

weight and track conditions.

Proceed as follows:

1. With motorcycle on the stand, measure distance (A).

2. Take the normal riding position on the motorcycle with all

your riding apparel.

3. With somebody’s help, take the new distance (A).

B: axis of the panel screw

C: axis of rear wheel pin

Other manuals for Husqvarna TE 250 - 310 2011 I.E.

Questions and Answers:

Need help?

Do you have a question about the Husqvarna TE 250 - 310 2011 I.E. and is the answer not in the manual?

General