English - 29
Repair Instructions
WARNING!
If the spring tension is activated
on the starter pulley, the spring
can y out and cause personal
injury. Wear protective glasses.
7.1 Dismantling the starter
1
Loosen the four screws, which hold the starter
against the crankcase and remove the starter. See
gure 1a
3
Remove the clip in the centre of the pulley. Remove
the spacer and the pulley. See gure 3. Loosen the
screws on the cassette and remove the cassette
and spring.
Cleaning and inspection
Clean the parts and check:
• The starter cord.
• That the starter pawls on the ywheel are intact,
i.e. that they spring back to the centre and
move easily.
• To lubricate the return spring using light oil.
7 Repair instructions
2
Pull the cord out about 30 cm and lift it into the
notch on the outside of the starter pulley. Release
the tension in the return spring by letting the starter
pulley rotate anti-clockwise. See gures 1b and 2.
Fig 1b
Fig 2
Fig 3
Fig 1a
To Next Page
Loading...
