Husqvarna TrioBrake 550XPG - Assembling the Ignition Module and Flywheel

English - 33
Repair Instructions
7.7 Assembling the ignition module and
ywheel
1
Run the cables through the opening in the crank-
case. Screw the earth cable in place. See gure 11.
Fit the cabling to the stop button.
2
Position the cable channel as outlined in gure 11.
NOTE! Take care that the cable channel is posi-
tioned correctly under the ignition module so that
the cables are not crushed.
3
Place the ignition module in position. See gure 13.
Do not tighten the screws.
Fig 12
Fig 13
4
Fit the ywheel onto the crankshaft pin. Turn the
ywheel until the key ts into the key slot on the
shaft. See gure 12.
Tighten the screw for the ywheel.
5
Insert the plastic air gap tool, at a thickness of
0.3+- 0.1 mm, between the lugs on the ignition
module and ywheel. Turn the ywheel so that the
magnets are positioned opposite the ignition mod-
ule. Tighten the screws, at a tightening torque of
4.5- 6 Nm. Remove the plastic air gap tool. Fit the
intake system as outlined in “7.14 Assembling the
intake system”, the tank unit as outlined in “7.16
tank unit”, and the air lter as outlined in “Assem-
bling the carburettor”.
6
Press the ignition lead into the holder on the parti-
tion wall.
7
Then t:
• The air nozzle
• The guide rail and press the cable in place
• The spark plug hat by unscrewing the piston stop
• The starter, at a tightening torque of 2.5-3.5 Nm
• The cylinder cover
Fig 11