Husqvarna TrioBrake 550XPG - Replacing a Broken Return Spring; Starter Assembly

English - 31
Repair Instructions
WARNING!
Exercise care to ensure the spring
does not y out and cause person-
al injury. Wear protective goggles.
7.4 Replacing a broken return spring
1
Remove the clip in the centre of the pulley. Remove
the spacer and the pulley. See gure 3a.
2
Remove the broken cassette and replace it with a
new one.
3
Replace the spacer and the clip in the centre of the
starter pulley. Load the return spring, see “Tension-
ing the return spring”. See also the “Dismantling
the starter” chapter.
7.5 Starter assembly
1
Position the starter against the crankcase and
tighten the screws at a tightening torque of
3-4Nm.