50 - English
7.15 Tank unit
Dismantling
1. Drain the fuel from the tank.
2. Remove the cylinder cover, the clutch cover, the
chain and the bar. See the Operator’s Manual.
Dismantle the carburettor as outlined in “Dis-
mantling the carburettor”.
3. Loosen the hoses A to C. See gure 52.
4. Loosen the screws E. See gure 53.
5. Loosen the movement limiter G. See gure 55.
6. Pull out the hoses A to C in the bottom of the car-
burettor compartment. Unhook the throttle cable,
D, from the intake bellows before pulling out from
the bottom of the carburettor compartment.
Repair Instructions
WARNING!
The fuel used in the chain saw has
the following hazardous properties:
1. The uid and its vapour are poisonous.
2. Can cause skin irritation.
3. Is highly inammable.
7.16 Venting the fuel tank
The two-way valve has the following properties:
• Controlled opening pressure in both direc-
tions, which prevents a positive pressure or a
vacuum developing in the fuel tank and impair-
ing engine performance. This also prevents fuel
leakage.
• Opening pressure outward 100-450 mbar.
• Opening pressure inward (vacuum) max.
70mbar. (2 locations)
Test
Opening pressure outwards:
1. Open the tank lock and leave it open during the
entire test. Drain the fuel from the tank.
2. Loosen the positive pressure hose as outlined
in gure 56. Connect the pump, ref. no. 531 03
06-23, to the tank valve H.
3. Switch the pump to vacuum mode.
4. After pumping the indicator should be between
10-45 kPa.
Opening pressure inwards:
1. Open the tank lock and leave it open during the
entire test. Drain the fuel from the tank.
2. Loosen the positive pressure hose as
outlined in gure 56. Connect the pump,
ref. no. 531 03 06-23, to the tank valve H.
3. Switch the pump to pressure mode.
4. After pumping the indicator should stop at max.
7 kPa.
E
E
E
E
E
D
C
B
A
Fig 52
Fig 53
Fig 55
G
Fig 54
NOTE!
Exercise care so that the fuel hose and
throttle cable are not damaged.
To Next Page
Loading...
