38 - English
7.13 Assembling the intake system
1
Assemble the intake system.
2
Fit the lower screws of the intake system using the
POP-out hole and the fuel hose hole. Fit the other
screws. Fit the fuel hose and the throttle cable to
their attachments. See gure 24.
Fit the rubber grommet to the throttle cable. Push
the tank back in position. Hook on the cabling to
the holder on the intake system.
3
NOTE! Press the lug on the carburettor in place on
its bracket on the partition wall. See gure 24.
Fit the carburettor, the lter holder and the air lter
as outlined in “Assembling the carburettor”.
Cleaning and inspection
Clean and check all parts carefully. Parts must
be replaced if cracked or showing signs of other
defects. Always use original spare parts.
5
Dismantle the intake system. Pull up and then out-
ward. See gure 26.
Fig 26
I
Fig 25b
To Next Page
Loading...
