Huvitz HLM-7000P - Page 28

Auto Lensmeter HLM-7000P
27
No
Component
Removal method
1
BACK BONE
- Disconnect ‘PD Bar Board’ cable from ‘Main Board’.
- Remove cap [18]
- Reference : 3.3.1 PD-Bar Sub-Assembly
- Please see the drawing for disassemble, as needed
- Be careful to prevent from interfering with the [17]
which is included in the optical components
when assembling or disassembling the PD assembly.
- Assembly is the reverse procedure of disassembly.
2
B6_LED-BONE-ASSY
3
SHAFT FIX BRACKET
4
GUIDE SHAFT 4
5
B4_FOOT-EXTENSION-SPRING
6
FOOT MOVING BLOCK DAMPER
7
FOOT MOVING BLOCK ASSY
8
B4_FOOT-FRAME-ASSY
9
FIXING BRK ASSY
10
B4_PEN-SLIDE-ASSY
11
B2UP_PEN-FRAME-ASSY
12
PCB ASSY(CMOS B/D-V100)
13
B4_CCD-CAMERA-COVER
14
COVER TOP 3
15
B2UP_PD-BAR-ASSY
16
PD PINION ASSY
17
B4_FILTER-HOUSING-ASSY
18
FILTER-HOUSING-CAP-13 사출
19
HARNESS(MB(CN10) TO CMOS)