Installation and Maintenance Manual
27
Clock Functions
Setting the time and Date
The Smart Touch Controller is equipped with a 24 hour (military time), 365 day clock, so that events of
significance can be logged and stamped with both the time and the date. This feature is useful to record
key historical operational data and a log of Alerts, Faults and Errors, all of which can be accessed from
the RS232 port with a PC computer or a PDA using the Palm OS. Optional Hy-Security supplied
software and cables are required in order to read this data.
1. To set or adjust the time or date, go the User menu item [CL_0] and then push the Select button
so that [CL_0] blinks. Press the Next button to change the setting from [CL_0] to 1, 2, 3 or 4
depending upon which setting is to be altered. 1 = minutes / 2 = hours / 3 = days / 4 = months.
2. Once you have selected a blinking setting [CL 1-4], push the Select button (Note: you must push
the Program Menu button for software versions prior to h3.01) to change the display to a blinking
(adjustable) value. The following letters will be displayed on the left side to aid in knowing which
setting is being made:
a. Setting [CL 1] = minutes – display [ni 0–59]
b. Setting [CL 2] = hours –--- display [hr 0–23]
c. Setting [CL 3] = days –---- display [dA 1-31]
d. Setting [CL 4] = months – display [no 1-12]
3. Make any required change to the hour, minute, day or month in the typical manner by using the
Next or Previous buttons, then press the Select button to enter the change, just as typical for
all of our other menu settings.
4. When done, you may have to restore the setting to [CL 0] because the Menu button may
not function to allow the user to exit the clock setting mode until the user has changed the
setting back to [CL 0], which places the clock in its normal display mode.
5. A lithium disk battery supports the clock so that the time is not lost when the main power is off.
This battery should be replaced about every five years. Use a DL 2025 / DL 2032 or CR 2025 /
2032 battery.
To Next Page
Loading...
