Hycontrol REFLEX User Manual

Ref: REFLEX/SCANFLEX MANUAL
EDITION 1: JULY ’97 6
Configuration 3 - With 2 or 4 Relays Per Point - Module SR-10
RS485
Reflex
Controller
Scanflex
SM-10
Multiplexor
Group and
status alarms
RS232
10 Transducers
Transducer link RG62A/U co-axial cable
(and t/comp if specified)
Scanflex
SR-10
Relay
Module (1)
10 x 2
Relays
Scanflex
SR-10
Relay
Module (2)
10 x 2
Relays
In addition to the functionality of Configuration 1 the Relay Module provides two alarm relays
for each measurement point. A second Relay Module can be added to either increase the
number of relays per point to 4 or duplicate the relay settings of the first (SR-10) module.
Dependent on how LK4 or LK5 are set. (See Pages 62 and 63 for details).
Configuration 4 - With both Analogue and Relay Outputs
Scanflex
SR-10
Relay
Module (2
)
10 x 2 Relays
RS485
Transducer link RG62A/U co-axial cable
(and t/comp if specified)
Scanflex
SR-10
Relay
Module (1
)
10 Analogue
outputs
Reflex
Controller
Group and
status alarms
RS232
10 Transducers
Scanflex
SM-10
Multiplexor
Scanflex
SA-10
Analogue
Module
10 x 2 Relays
All Modules can be connected
to the RS485 in any order
Configuration 4 shows maximum outputs available per point i.e. 1 analogue and 4 relays.
This configuration provides all the discrete outputs that can be programmed for each
measurement point. Two Relay Modules provide 4 independently programmable relay switch
points for each transducer.
If required additional Analogue and/or Relay Modules can be added to duplicate the same
signals in different locations or control rooms. Up to 14 Modules can be connected, although
the total system configuration must not exceed 15 modules including the one Multiplexor.

Hycontrol REFLEX Specifications

General

Brand	Hycontrol
Model	REFLEX
Category	Controller
Language	English