Hycontrol REFLEX User Manual

Ref: REFLEX/SCANFLEX MANUAL
EDITION 1: JULY ’97 5
Below are detailed a number of typical configurations:-
Configuration 1 - Minimum System
RS485
Reflex
Controller
Scanflex
SM-10
Multiplexor
Group and
status alarms
RS232
10 Transducers
Transducer link RG62A/U co-axial cable
(and t/comp if specified)
Minimum system to provide:-
A display of measurement for up to 10 points and 5 group alarms which are designated as
shown on Page 4.
An analogue output is available from the controller but it varies as the instrument scans each
point.
The RS232 output enables a local computer or PLC to obtain data from all measurement
points.
Configuration 2 - With Analogue Output - Module SA-10
RS485
Reflex
Controller
Scanflex
SM-10
Multiplexor
Group and
status alarms
RS232
10 Transducers
Transducer link RG62A/U co-axial cable
(and t/comp if specified)
10 Analogue
outputs
Scanflex
SA-10
Analogue
Module
In addition to the functions provided by Configuration 1, the analogue module provides a
continuous analogue output for each measurement point.

Hycontrol REFLEX Specifications

General

Brand	Hycontrol
Model	REFLEX
Category	Controller
Language	English