Hyd-Mech S20 SERIES III User Manual

2.7
WORK STOP
The work stop is used to set a consistent cut length from 0 to 34 inches. The photo shows the stop at a short length, which
is adjusted with one or both of the locking handles. The bar with the actual stop attached to it can be removed, turned 180
degrees end for end, and inserted for longer lengths. The work stop may also be swung out of the work area when it is not
required.
WORK LAMP
Part # 371789
Work stop assembly

Hyd-Mech S20 SERIES III Specifications

General

Brand	Hyd-Mech
Model	S20 SERIES III
Category	Saw
Language	English