EasyManuals Logo

Hyd-Mech S20 SERIES III User Manual

Hyd-Mech S20 SERIES III
50 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #27 background imageLoading...
Page #27 background image
3.3
9. With the blade in place, turn the tensioner handle clockwise until Bade Tension Display shows required value.
Recommended blade tension is 1250 - 1350 kg. If blade is under tensioned the blade motor will not start
10. Replace the blade cover and close wheels door.
11. Jog the blade a few rotations to check that the blade is not moving in or out on the blade wheels. As the blade
tracking will stay fairly constant, it should be checked occasionally by measuring the gap between the back of
the blade and wheel ange. The gap should measure .040-.080”. If the tracking requires adjustment, follow the
instructions below.
BLADE TRACKING ADUSTMENT
First, inspect the blade wheels for wear or damage and repair as required, Blade tracking adjustment should always begin
at the wheel where the tracking is farthest out of specication. Using the instructions below, adjust the worst wheel, jog the
blade and recheck both wheels. Repeat this process until both wheels are within specication.
Idler Wheel Adjustment
The Idler Wheel must be adjusted so that it is aligned with the drive wheel. The purpose of the adjustment is to ensure
that the back of the blade remains about .040-.080” away from the wheel ange during rotation.
1. Release blade tension.
2. Open wheel cover.
3. Loosen the screw and using a mallet tap the shaft in or out.
4. Restore the machine and run blade for few wheel rotations.
5. Check the distance between the blade and wheels ange.
6. If necessary repeat above steps until proper gap is achieved

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Hyd-Mech S20 SERIES III and is the answer not in the manual?

Hyd-Mech S20 SERIES III Specifications

General IconGeneral
BrandHyd-Mech
ModelS20 SERIES III
CategorySaw
LanguageEnglish

Related product manuals