HydraMaster Corporation
Page 1-16: General Infromation
Boxxer 421
Machine Tie Down Cleats
Secure the machine to the floor of the van with the four tie down cleats provided.
This safety measure will ensure that the machine will not slide inside the van. See the
following illustration for the correct installation.
Figure 1-3 Installation Using Tie-down Cleats
Ensure that the machine is well secured to the floor of the van with the hardware
supplied. A sudden or crash stop will cause the machine to rocket forward. Protect
yourself and the machine. SECURE IT!
It is recommended by the manufacturer that the exhaust from the front of the
machine be vented down under the truck to prevent carbon monoxide from
entering the job site. Always park the truck so the exhaust is blowing away
from the job site.
The manufacturer also recommends the installation of aluminum vents in the
truck roof to allow heat to escape.
Never operate this machine with a portable gas can inside the truck. Doing so
increases the risk of a fire or explosion.
Mount a fire extinguisher just inside the rear or side door for emergencies.
To Next Page
Loading...
