INSTALLATION
WARNING: Customers are cautioned to provide adequate protection, warning and safety equipment necessary to
protect personnel against hazards involved in the installation and operation of this equipment in the system or facility.
Do not use air blowers on explosive or hazardous gases. Casing pressure must not exceed 25 PSIG (1.72 bar g). Each
size blower has limits on pressure differential, running speed, and discharge temperature, which must not be exceeded.
These limits are shown on the Specification Sheet "Maximum Operating Limits” on page 10.
WARNING: Keep hands, feet, foreign objects and loose clothes from inlet and outlet openings to avoid injury or
damage if lobes are to be rotated at this point.
LUBRICATION
Do not start up the blower until you are positive that it has been properly and fully lubricated. (See Lubrication Section
on page 6.)
WARNING: Do not operate equipment without adequate silencing devices since high noise level may cause hearing
damage. (Reference OSHA Standards.)
5
To Next Page
Loading...
