Smartec HSA 5
SERVICING SAFETY
All procedures will require the vehicle to be
disabled in order to prevent possible injury to
the servicing technician and/or bystanders.
Remove all SMARTEC
®
controllers before
performing any welding repairs on the vehicle.
De-energize the system/components by
waiting 1 minute prior to performing any repairs
or adjustments.
Never touch two posts of any battery at the
same time. Never touch the body frame and
the positive lead at the same time.
As a General rule, keep batteries free of
debris. Reference machine owners manual
for proper battery cleaning and maintenance
procedures.
Some cleaning solvents are fl ammable. Use
only approved cleaning materials: Do not use
explosive or fl ammable liquids to clean the
equipment.
To avoid possible fi re, do not use cleaning
solvents in an area where a source of ignition
may be present.
Discard used cleaning material in the
appropriate containers.
SAFETY Continued.
WARNING
POTENTIAL FOR SERIOUS INJURY
Inattention to proper safety,
operation, or maintenance procedures
could result in personal injury, or
damage to the equipment. Before servic-
ing or repairing the SMARTEC
®
system,
fully read and understand the safety
precautions described in this section.
Refer to the vehicle manufacturer’s
operation and service instructions be-
fore performing any service or repairs.
To Next Page
Loading...