Hydro-Gear T2 - Expansion Tank Hose and Fitting

32 T2™
Refer to Figure 26
Disassembly
1. Remove the expansion tank hose (141).
2. Remove the O-ring (142) from the expan-
sion tank fi tting (140) and discard.
3. Remove the expansion tank fi tting (140).
Inspection
1. Inspect the fi tting for damage and replace
if necessary.
Assembly
1. Install the fi tting into the main housing. Refer
to torque chart on page 15.
2. Install a new O-ring (142) onto the fi tting.
3. Place the expansion tank hose (141) onto
the fi tting (140).
EXPANSION TANK HOSE AND FITTING
Figure 26, Expansion Tank Hose and Fitting
141
142
140