hydrow.com | 1918 | Hydrow Wave User Guide | 01/2023
Updates
Available software updates will be installed on your Hydrow Wave automatically
when it is powered on but not in use. If your Hydrow Wave is powered o, you’ll be
prompted to install updates when you power it on.
Repairs and replacements
If you need to order replacement parts or your Hydrow Wave needs service or
repair, contact our Hydrow Member Services team.
Storage
See hydrow.com/support for complete storage recommendations.
Store your Hydrow Wave indoors in a safe, dry place, away from direct sunlight.
To collapse your Hydrow Wave’s monitor arm (F) for storage or moving:
• Turn o and unplug your Hydrow Wave.
• While supporting the monitor arm (F) with one hand, remove the monitor
arm pin (O) with the other hand.
• Slowly collapse the monitor arm (F).
• Replace the monitor pin (O) into the front frame (A).
When moving your Hydrow Wave between floors or buildings, we suggest also
removing the monitor (G) and storing it securely. See the Attach the monitor
section and follow the steps in reverse order to detach the monitor.
WARNING Do not store your Hydrow Wave upright without the the upright storage
system compatible with your rower.
NOTE upright storage systems are NOT interchangeable between products.
Please see shop.hydrow.com to find the upright storage system compatible with
your rower.
Maintenance and Care
WARNING The Hydrow Wave’s safety level can be maintained only if it is
examined regularly for wear, including, but not limited to, its handle, handle strap,
foot straps, track, power cable, and seat. If any worn or defective parts are found
upon inspection, immediately cease using the Hydrow Wave until repairs or
replacements are made.
WARNING Do not allow any cleaning solutions, water, or other liquids to enter
the body of the Hydrow Wave.
WARNING Ensure the Hydrow Wave power cord is fully seated before each use.
NOTE Servicing of internal components must be done by an authorized service
representative, or your warranty will be voided.
Cleaning
After each row:
Clean your Hydrow Wave (especially the seat and handle) thoroughly using a
damp cloth.
Clean the touchscreen using wipes designated for screen cleaning on electronics.
Use a damp cloth to clean the seat track thoroughly by wiping its full length.
Clean the top, sides, and underside of the rail to remove any sweat, dust, or other
buildup for a smooth rowing experience.
NOTE DO NOT use lubricants or degreasers (such as WD-40) on the seat rollers
or rail. If you have any diculties with smooth sliding of the seat after cleaning
please contact Hydrow Member Services.
Monthly:
Use a dry cloth to remove any dust from the Hydrow Wave (especially the circular
air vents on both sides of the flywheel).
Remove the seat (H) and clean the entire track and rollers as described above. See
the previous Attach the seat section for instructions on removing the seat (H).
Every six months:
Refer back to this guide and tighten all bolts mentioned in the Assembly and
Setup section.
To Next Page
Loading...