Hypercom T7 series - Page 34

Equipment Information
940114-020 Hypercom Point-of-Sale 1-17
2EZMKEXMRKXLVSYKLXLI&SSX0IZIP
The following table provides tips for navigating through the terminal’s Boot level.
'LERKMRK7IXXMRKWMRXLI8IVQMREPW&SSX0IZIP
There are approximately 22 settings in the terminal’s Boot level. Some can be changed and
other cannot be changed. This procedure identifies the only option settings you can change.
One of the following screens appear, depending on the terminal’s EPROM version and the
previous action taken at the terminal’s Application level.
7GVIIR
Key Used to...
Enter Scroll down the Boot level menu.
Clear Scroll up the Boot level menu.
Cancel Return to the
Please Initialize or Call Help - F E screen, or
Return to the
Please Initialize or Call Help - PE screen
Function 3, Enter Exit the Boot level.
N
OTE: This option is available only if existing software is loaded.
WARNING
If any Boot level settings not identified in this procedure are changed, the terminal may not
function properly.
EPROM version Terminal display
If the EPROM is less than 2.00, the terminal
displays the following message.
NOTE: FE means Format Error, indicating you
are in Boot level.
&21),*85(7(50,1$/
25&$//+(/3)(