Chapter 1
1-18 T7 Series Troubleshooting Manual 940114-020
7GVIIR
7GVIIR
Step-by-Step
To change settings in the terminal’s Boot level:
EPROM version Terminal display
If the EPROM is 2.00 or higher, the terminal
displays the following message.
NOTE: FE means Format Error, indicating you
are in Boot level.
3/($6(,1,7,$/,=(
25&$//+(/3)(
Previous action and EPROM version Terminal display
If the the terminal’s software and initialization
parameters have not been deleted at the
terminal’s Application level, the following
message appears.
NOTE: FE means Format Error, indicating you
are in Boot level.
3/($6(,1,7,$/,=(
25&$//+(/3)(
Step Action Terminal display
1 Press the key sequence: Function 9, 9, Enter. 0(5&+$17)81&7,21
2 Press the key sequence: Function 3, Enter. 352*5$0)81&7,21
3 The terminal displays the current Leased Line,
Dial, and LAN options.
The dial mode should be at the default setting of
01.
Press the key sequence: Function 0, 1, Enter or
press Enter to bypass this field.
//',$//$1
4 The terminal displays the current CU Address for
LAN configuration.
The dial configuration should be at the default
setting of 30.
Press the key sequence: Function 3, 0, Enter or
press Enter to bypass this field.
&8$''5
To Next Page
Loading...
