Hypercom T7 series - Pre-Load and Host Messages

Error Messages
940114-020 Hypercom Point-of-Sale 2-5
n
If the terminal has an EPROM of 2.00 or higher, verify the Printer setting is correct in the
terminal’s Boot level. For instructions, refer to “Verifying the Printer Setting” on page
1-21.
)6636;VSRK8VERW
ERROR—Wrong Trans indicates the Visa II Table in the Term-Master’s profile was not correctly
filled out with the required information for the Visanet, NDC, or MAPP modules on Hypercom’s
System Software.
&IJSVI0SE HMRKSV-RMXMEPM^MRKE 8IVQMREP
The following messages appear before loading or installing a terminal.
4PIEWI-RMXMEPM^ISV'EPP,IPT*)*SVQEX)VVSV
Format Error indicates the terminal is in Boot mode and requires an initialization personality load.
4PIEWI-RMXMEPM^ISV'EPP,IPT4)4VSKVEQ)VVSV
Program Error indicates the terminal requires a full program load and an initialization. After the
program load is complete, initialize the terminal.
,SWX1IWWEKIW
The terminal displays messages it receives directly from the host. These messages can be up to
40 characters long and may display on both lines of the terminal display.
To verify that the terminal receives a host message and not a terminal message:
n
Turn on enhanced dialing by pressing the key sequence: Function, 9, 8. If the terminal
displays
Dialing Now, then Processing Now and displays the corresponding response,
the message is a host message.
n
If the terminal displays Processing Now and appears to be inactive, the message is
likely a terminal message.
Typically the host transmits response codes which cause the terminal to display appropriate
stored messages.