HyPrecision Predictive waterjet pump Operator Manual 810120 205
9 – Installation
Installation
Make the connections to the utility panel
The diagram on page 36 shows the flow of water through the pump system.
CAUTION
Compressed air is an energy source that can eject with force. Be careful when connecting to and
disconnecting from this energy source.
Water-cooled system
Do not connect the W
ASTE WATER OUT hose and the COOLING OUT hose together. Connecting these
hoses can cause cooling water to back up into the system, which can cause damage to the
bleed-down valve and intensifier parts.
CAUTION
Air-cooled pump
If the C
OOLING IN hose and the COOLING OUT hose are not connected to the external heat
exchanger before starting the motor, the hydraulic hoses can be damaged.
WARNING
Do not tighten a fitting too much. The fitting can fail.
CAUTION
To prevent dirty water from entering the bleed-down valve, install the WASTE WATER OUT hose so
that it is below the fitting on the pump.
WARNING
Do not use an adjustable wrench on high-pressure fittings.
To Next Page
Loading...
Need help?
General
